1. Transportation & Logistics
The entire roll is packed and shipped in rolls, which can be rolled into cylindrical boxes. Unlike granite or marble, which can only be packed flat in wooden crates, shipping by sea is small in volume and has almost zero damage. The freight cost is 50% lower than traditional stone.
The longest single roll can reach 30 meters. There are fewer splicing gaps for large surfaces, and the labor cost for laying is directly halved.
There is no cumbersome wooden frame packaging. Customs clearance and unpacking are free of the trouble of waste wood fumigation. In some countries, fumigation procedures can be waived.
2. Installation & Construction
No need for steel frames for hanging, no need for pre-buried parts. Tiles, wooden boards, cement walls, or iron sheets can be directly pasted on exterior and interior walls. Old buildings can be renovated without damaging walls or removing existing finishes.
A regular utility knife can be used for cutting. No need for large cutting machines at the construction site, no dust pollution. Indoor construction can be carried out without stopping.
It can be shaped into cylinders, arches, curved ceilings, and various irregular designs. The minimum bending radius is 5 cm. Hard stone cannot achieve a seamless curved arc.
The weight is only 1/15 of traditional stone. There is no risk of detachment or falling off on high-rise exterior walls. Many European and Central Asian regions prefer this due to fire safety and building regulations.
3.Durability & Climate Adaptability
Temperature range: -40℃ extreme cold to 90℃ extreme heat. Freeze-thaw cycles and direct sunlight will not cause cracking or peeling. It is suitable for cold northern winters and hot regions in the Middle East.
A2 grade non-combustible fireproofing. In case of fire, it will not drip toxic smoke. Office buildings, hotels, schools, and public construction projects can easily pass fire safety inspections.
4.Environmental Protection & Certifications
Non-radioactive, free of formaldehyde, low VOC. The natural stone skin only removes the surface layer of the rock, and the internal radiation layer is completely discarded. Most MCM models are made from recycled waste materials and are classified as green building materials. They can apply for local environmental protection building material subsidies.
Waste can be crushed and recycled for further processing. There is very little construction waste, which complies with the EU environmental recycling regulations.
